Walk-through metal detectors have become a very important security inspection equipment, which can effectively detect the guns, daggers and other metal weapons carried. In addition, other industrial sectors, such as mints, cigarette factories, etc. also widely use metal detectors. Then it is very important to know how to install a walk-through metal detectors .

Installation environment

How to install the walk-through metal detectors?

Precautions during installation

1. Installation environment

Keep away from metal objects. As we know, through metal detectors use electromagnetic fields to detect whether metal objects are carried. Therefore, when installing the crossing metal detector, it should be 30 cm away from fixed metal objects. If it is a large metal object that can be moved, it should be about 50 cm away from the device. Otherwise, sensitivity will be affected and false alarms will be generated.

Keep the installation ground level. The ground should be level and fixed to avoid the movement of the equipment due to the movement of people or the influence of other objects.

Avoid interference from electromagnetic radiation. Since the technology of the device works through electromagnetic fields, any sources of electromagnetic interference and electromagnetic radiation may affect the detection. The parameters of keeping distance depend on the installation environment and different installation environments.

2. How to install the walk-through metal detectors?

First, please read the precautions carefully before installing the metal detector, including the installation environment mentioned above, to ensure the normal operation of the product and avoid external interference.The installation situation of each equipment may be different, please refer to the manual for specifics.

Take this detector out of the box and check it according to the instructions.Place the door panel on the ground and use the bolts that connect the door panel to the beam. The bolts must be tightened.Open the cover under the front beam, and then insert the probe cable into the host into the hole on the beam. Connect the main frame to the beam with bolts, and then tighten the bolts.Insert the signal cables into the corresponding holes on the left and right according to the color. Tighten the right door panel, tighten the fixing ring, and then close the cover.Set up and move the metal detector to the designated installation location.Connect the power cord to the power connector on the side of the host. Then press the power button to enter the working state.

3. Precautions during installation

Pay attention to the installation environment, including ground conditions, whether it is close to metal, and whether it is close to electromagnetic fields.

Before installation, clearly distinguish the left and right sides of the motherboard and the panel. If the direction marks are not clear, please follow the same direction for the button panel on the motherboard and the indicator lights on the panel.

Set screws between the panel and the motherboard to avoid shutting down, which will affect the detection accuracy and cause accidents. Therefore, the screws must be tightened.

Through the above introduction, I believe that for the installation environment, how to install and some points of attention should be understood. If there is anything unclear about walk-through metal detectors , you can call for consultation. We will solve your problem with high-quality service.